Transfer call

sameh · Post by **sameh** » 09 Jan 2010 05:12

Hi all

I know how make transfer from digital aphone
but I don't from analog set

Please Some One Tell me how I can make Transfer call from analog set

thank & Best Regard

brainwave · Post by **brainwave** » 10 Jan 2010 03:09

You can press the flah or R button during the call you get dialtone choose the internal number of the ectension you want to transfer to and than you can put the habdset at the phone or you can wait until the tranfering extension answered the cal and than put down the handset

sameh · Post by **sameh** » 13 Jan 2010 07:11

Thank Mr. Brainwave

first I have OXO System (not OXE)

on Analouge Set I make Call with 110 Extension

then I try To Make second call with 111

So I press on Flash Button but the first call with 110 released automaticly

please tell me how Ican make transfer

thank and best regard

tincho.rn · Post by **tincho.rn** » 13 Jan 2010 08:15

Hi. You have a problem with the detection of the flash pulse. This is because the flash in your phone set is longer than the flash spected by the PBX. You have two options:
1) decrease the flash timer in the phone set. Usually you have 300 ms and 600 ms. Then choose 300 ms.
2) configure the PBX. You have to change a memory variable. I am not an OXO expert. But check for TimeDurati variable in the noteworthy address. Always take into account that Flash timer should be lower than OnHook timer. Check the flash timer of your phone set. Then configure the variable as explain in the noteworthy document.
If you need further assistance, post again please. Regards.

sameh · Post by **sameh** » 14 Jan 2010 05:50

Dear Mr.tincho.rn

thank you for your great aid

I Configured the flash timer to be 300ms

then the transfer and suffix become active

thank you

best regard

Boniface Kutu · Post by **Boniface Kutu** » 15 Jan 2010 08:28

Can as well use hookswitch!

failure.ehia · Post by **failure.ehia** » 08 May 2010 01:38

HEllo where can i decrease the flash timer on the phone set? and whre can i change the TimeDurati?

elkiwi · Post by **elkiwi** » 10 May 2010 08:39

It depends on the phone. In OXO go to OMC --> System Miscellaneous --> Memory Read/Write --> Other Labels --> TimDurati.

failure.ehia · Post by **failure.ehia** » 10 May 2010 21:10

Try to view below: that my timsurati. the question how can i change?

elkiwi · Post by **elkiwi** » 11 May 2010 09:20

Look at TC0080 - Noteworthy addresses, there is very well explained it. Here you have an advance:

This flag contains 5 timers for analogue sets (2 wire). Length = 10 bytes / 8 ms steps.
- Off_hook validation Timer,
- On_hook validationTimer,
- Flashing detection Timer,
- Digit detection Timer (dialling),
- Eb (earth button) detection Timer.

Good Luck!