Problem during GD-2 startup

Eliott · Post by **Eliott** » 15 Feb 2010 05:19

Eliott wrote:...DIL switch set as...

JoelO wrote:Did you change the dip switch settings to re-load the nand flash?

The answer my friend?

Post by **vad** » 15 Feb 2010 06:27

Load GD binaries, NOT close PC Installer!!! Wait GD start (eMG login), enter IP parameters (with mgconfig command), when GD after reboot will be in service - close PC Installer application.

Elandryl · Post by **Elandryl** » 16 Feb 2010 06:05

I already had similar issue.
When the card start i had only the BIOS menu, i didn't strike Ctrl+B but the BIOS print up himself on my consol.

After LOLA or BIOS flash the card wont startup and reboot again and again.
i never see the boot process or dhcp process.

I had to make a RMA :/ (according ALU support)

sipmotor · Post by **sipmotor** » 06 Mar 2010 06:08

If the DIL switches are OK, there may be another Problem:

ALIZE informations :
Memory Detected : 131072 Ko
Flash Detected

Memory Detected KO?
You may have a faulty NAND Memory on your GD2 Board...

kind regards