How to reset the alcatel 4400 PBX v24 port ?

lgxbin · Post by **lgxbin** » 25 Nov 2004 00:25

For some reasion the the alcatel 4400 pbx's v24 port was doesn't work,what can I do to reset the v24 port without reboot the alcatel 4400?
thank you.

Post by **vad** » 25 Nov 2004 01:59

If 4400 and ComB, ComC or ComD. You can try "ttyconf" command, you can change current state to "off" and after to "respawn".
And another command "v24_config".
Sometimes maybe intresting to "kill" process (application) which occupy this port (f.e. "mgr" through analog modem on ComB - if link will disconnected - you will have "hang up" mgr process on tty1a port and for repairing will be enough to kill "mgr" process).

goldy · Post by **goldy** » 26 Nov 2004 03:58

as Vad said, there are the two commands (depending on S/W version) available.

What ports are you using, eg C/D, or maybe using a TA? Do you have CPU duplication? What application are you tring to run on the port? Can you echo to the port from a terminal connection?

I have just had a maasive battle trying to get some going on a site, so if I can help you, then great