CPU7-2 do not provide Login prompt for RMAB !!!

[doublevand981]

Dear All,

i using crystal R.9.0 with RMAB for remote maintenance,
I setup for RMAB connect to CBRMA and CPU.
i can local console to RMA by ExA port. and also can dial from remote modem to RMA.
but for both cases whenever i got to "menu/connection/ SyA" then i did NOT get login prompt from CPU.

i still get login prompt from CPU by A0 port as normal


Any one face this issue pls help me ??

thanks so much

[sander.foekema_DUP]

Best doublevand981,

It is important that all cables are connected before the rack is switched on.

did You use the right cables?

Groet,

Sander

[vad]

Check connection (f.e. Red and Black mark for RMAB-CBRMA cabel). Check connectors (on backplain for RMAb board, on both side - may be you have damaged pins.

[doublevand981]

thanks you, sir

i found problem in cable connector, it was broken.