I've got a major problem by a customer. The customer had a total power down of the 4400. When the power was back on the system everything was working fine except the Ip Phone's.
When I'm starting up a phone I see step 1 and 2 after that is says for 1 second trying to connect and after that is stays in Receiving.
If i remove the mac adres of the phone in mgr and I restart the Ip phone it is goint to step 1 and 2 than trying to connect and that the voice guide says. Please type you phone number. If I do that following with the code. The phone is restarting. After restarting it is aggain getting stucked in Receiving.
If I'm looking in the incidents I see continu the folowing incidents every seccond is every phone generating a incident:
19/05/06 17:00:18 000002M|19/03/0/011|=3:0378=IP Phone sig incident 12,(0,8),00:80:9f:54:30:5b,412
19/05/06 17:00:18 000002M|19/03/0/021|=3:0378=IP Phone sig incident 12,(0,8),00:80:9f:55:00:fd,428
19/05/06 17:00:18 000002M|19/03/0/016|=3:0378=IP Phone sig incident 12,(0,8),00:80:9f:3d:83:b0,418
The explenation of it is:
INCIDENT NUMBER: 378
Network indicator: Alcatel 4400
OBJECT CLASS: Dhs3Terminal
EVENT TYPE: EquipmentAlarm (4)
PROBABLE CAUSE: EquipmentMalFunction (15)
SEVERITY: Minor
"IP Phone sig incident P1"
"P1 : Error type"
"P2 : Crystal number of the signaling board (optional)"
"P3 : Board number of the signaling board (optional)"
"P4 : Ethernet Address"
"P5 : Set number of set if possible"
"Incident Format : P1,(P2,P3),P4,P5"
"Signaling link problems on"
"link establishment or existant link shutdown"
"Several causes"
"Depend of the error value P1:"
" 0 Lien out of order - IP Coupleur IP not initialized"
" 1 Lien out of service - MAC Address already allowed"
" 2 Lien out of service - IPV6 not supported"
" 3 Link out of service - IP Coupleur lack of ressources"
" 4 Link out of service - Non existant link"
" 5 Lien en service - Link already set"
" 6 Link out of service - Link down"
" 7 Link out of service - IP coupleur Internal error"
" 8 Lien en service - Link established"
" 9 Link out of service - Network error"
" 10 Link out of service - Peer not connected"
" 11 Link out of service - On peer demand"
" 12 Link out of service - On CPU demand"
" 13 Link out of service - IP coupleur internal error"
" 14 Link out of service - IP coupleur out of service"
" 20 Link On on a Out Of Service Set - idle state -"
" 21 Link On on a Out Of Service Set - active state -"
"no reaction of the system."
"Check IP ressources boards within ip phone"
"Check the physical connexion plug"
"On Cause 20 and 21, only notice the problem, and give"
"it to the R&D support. This is a defense mecanism which"
"should be actif only on a very bad IP network.";
Can somebody help me?
I've already reboot the cpu, installing a backup from the previous week. Install a phone with a static adres.
I've created a lanpbx.cfg file but that also didn't do the trick.
It is posible to open a telnet sesion te the phone and ping to the cpu an int-ip.
I'm out of clue's now.
IP Phones stays in Recieving Mode after power down 4400
-
cavagnaro
-
André
I've already done that. When I removing the mac adress and i reset the phone then the voiceguide says. Please put your phone number. If I do that then the phone resets and I'm in the same situation aggain. I've also tried to creat a total new user but with the same result. Tomorrow mornig I'me going te replace the Int-IP but I don't think that will do the trick. The following option is to load the release to the unactive partion and do a version switch. If that stil not gone work I'm fucked.
Normally I would go to the bussiness partner website but My company has no agreement with Alcatel and I'm not certified.
Normally I would go to the bussiness partner website but My company has no agreement with Alcatel and I'm not certified.
-
André
Today I Finaly find the solution.
This morning I changed the INT-IP and the Daughterboard but still no results. After that I loaded release 6.2 to the unactive partition and did a version switch but still no result. After that I take a better look to the configuation. I saw that the phone's were in IP Domain 1 and the INT-IP in IP Domain 0. I deleted Domain 1 and rebuilded it. At that moment al phone's where getting back in service. Nut when I resetted one phone I get the same error.
After that I decided to deleted IP Domain 1 and put al the Phone in 0. This was the solution. I was really happy that we find it. So if you have a same problem as me check your IP Domain configuration.
This morning I changed the INT-IP and the Daughterboard but still no results. After that I loaded release 6.2 to the unactive partition and did a version switch but still no result. After that I take a better look to the configuation. I saw that the phone's were in IP Domain 1 and the INT-IP in IP Domain 0. I deleted Domain 1 and rebuilded it. At that moment al phone's where getting back in service. Nut when I resetted one phone I get the same error.
After that I decided to deleted IP Domain 1 and put al the Phone in 0. This was the solution. I was really happy that we find it. So if you have a same problem as me check your IP Domain configuration.
-
André
Frank
You're right. Some colega's from a other compeny has changed the domain to get fax over ip working. Because the system was up the phone's didn't care about. After the reboot all was down and the ip phones won't come up. When I contact the guy from the other company he sayd O screw I think I forgot something. I was finking that something stuck becaude of the power down but in fact somebody else made a configuration fault. Anyway it is fixed and I had learned a lot from this.
You're right. Some colega's from a other compeny has changed the domain to get fax over ip working. Because the system was up the phone's didn't care about. After the reboot all was down and the ip phones won't come up. When I contact the guy from the other company he sayd O screw I think I forgot something. I was finking that something stuck becaude of the power down but in fact somebody else made a configuration fault. Anyway it is fixed and I had learned a lot from this.
