OXE common hardware and Cisco CM inter-connection

[hwhng]

Hi,

Just wonder anyone have experience connecting OXE common hardware with Cisco CM PRI interface (T1)? The preferred protocol is using QSIG. Since I need passing the CLIP information between two systems.

I understood Cisco has documentation and configuration information of how to connect Cisco CM with OXE but on OXE 4400 hardware. I need the information regarding on OXE common hardware.

Thanks.

[alex]

Actually the only difference is the type of the board that supports T2.

"/R 8.0 System documentation/System documentation/Private networks/Heterogeneous private networks/Heterogeneous QSIG networks" chapter contains all configuration procedures for both architectures.

[hwhng]

So I have OXE IP gateway with PRA-T1 (Primary rate access T1-ISDN) and running Release 8. Then I could connnect to non-Alcatel PBX via QSIG. Just wonder any specified license and options required to check / proviso (particularly in ACTIS) that I need on that?

Thanks.

[alex]

.... any specified license and options required to check / proviso (particularly in ACTIS) that I need on that?

Yes. For QSIG you need "corporate networking" license. When creating a private network link in ACTIS it will be added according to you requirements.