Problem with hybrid mode

[fripouille]

Hello,

I am having a problem with the hybrid ports on the 6360-P24X switch.
I am using port 25 and 26 in “fiber” mode, but every time I restart, I have to switch it back to copper mode and then to fiber mode so that the fiber link can work properly again (interfaces 1/1/25 hybrid-mode copper, interfaces 1/1/25 hybrid-mode fiber).

Without doing this, the CLI gives me this information:
+++ Link 1/1/25 Alias Aggregat Vers Coeur RGI operationally up
+++ Link 1/1/25 Alias Aggregat Vers Coeur RGI operationally down
+++ Link 1/1/25 Alias Aggregat Vers Coeur RGI operationally up
+++ Link 1/1/25 Alias Aggregat Vers Coeur RGI operationally down
+++ Link 1/1/26 Alias Aggregat Vers Coeur Administration operationally up
+++ Link 1/1/26 Alias Aggregat Vers Coeur Administration operationally down
+++ Link 1/1/26 Alias Aggregat Vers Coeur Administration operationally up
+++ Link 1/1/26 Alias Aggregat Vers Coeur Administration operationally down

I use several switches of the same model, and this is the only one with which I have this problem.

All my switches are running version 8.10.86.R04.

Does anyone have a solution?

Thank's a lot.

Laetitia.

[silvio]

Never seen this behavior. You can reset this switch to factory (new command) and configure it again. If the issue is than still there you should replace the switch via ALE service.
BR Silvio