Connecting via serial I get these messages:
Code: Select all
U-Boot (6.4.4.213.R01) (for OS6400, OS6850, and OS6855 platforms) (Jan 27 2011 - 05:18:45)
MPC8247 Reset Status: External Soft, External Hard
MPC8247 Clock Configuration
- Bus-to-Core Mult 4x, VCO Div 2, 60x Bus Freq 25-75 , Core Freq 100-300
- dfbrg 0, corecnf 0x1a, busdf 3, cpmdf 1, plldf 0, pllmf 3
- vco_out 400000000, scc_clk 100000000, brg_clk 100000000
- cpu_clk 400000000, cpm_clk 200000000, bus_clk 100000000
- pci_clk 66666666
CPU: MPC8247 (HiP7 Rev 14, Mask 1.0 1K50M) at 400 MHz
Board: Alcatel-Lucent OS6850 (Kite2)
I2C: ready
DRAM: 256 MB
FLASH: 8 MB
No environment variables found, using defaults
In: serial
Out: serial
Err: serial
No ethernet found.
IDE: Bus 0: OK
Device 0: Model: SanDisk SDCFB-96 Firm: Vdd 1.02 Ser#: i1328090504
Type: Hard Disk
Capacity: 91.7 MB = 0.0 GB (187904 x 512)
USB: scanning bus for devices...
OK led is blinking orange
The number 0 is shown in the "stack position" display
The switch freezes before the miniboot prompt.
Any ideas or I'm out of luck?