Hi!
Someboy knows commands CLI to change network configuration on Alcatel 4035-IP ?
I already know on 4018 and 8028s but not 4035-IP.
Thx!
Alcatel 4035-IP CLI commands
Re: Alcatel 4035-IP CLI commands
From system doc - To Consult / Modify the IP configuration of the IP-Phone, access the supervisor menu by successively pressing the and the # keys. This operation must be carried out between the start of set intialization and before the beginning of phase 6: "Establish UA signaling". After this, the supervisor menu can no longer be accessed, However, it can be accessed when reset is due to a power cut.
Re: Alcatel 4035-IP CLI commands
Thanks for replay
I'm trying to modify network parameters by telnet access, like I already did on 4018 and 8028s.
I can't access fisically to the 4035 that's why I need to use remote connection
Thx!
I'm trying to modify network parameters by telnet access, like I already did on 4018 and 8028s.
I can't access fisically to the 4035 that's why I need to use remote connection
Thx!
Re: Alcatel 4035-IP CLI commands
Not sure about telnet. 4035I - old sets. Very old
Re: Alcatel 4035-IP CLI commands
vad wrote: ↑22 May 2019 08:10 From system doc - To Consult / Modify the IP configuration of the IP-Phone, access the supervisor menu by successively pressing the and the # keys. This operation must be carried out between the start of set intialization and before the beginning of phase 6: "Establish UA signaling" mutuelles senior. After this, the supervisor menu can no longer be accessed, However, it can be accessed when reset is due to a power cut.
So which service could we contact if we want to make a complaint or something like that.