Alcatel Unleashed

I've used the same settings and the same cables. After setting up link aggregation, when both ports are connected, it operates normally even if both are disconnected and then only one is reconnected. However, if only one port is connected immediately after the initial setup, the port doesn't become ...

After setting up link aggregation on the Alcatel switch, communication doesn't work when only one port is connected. However, it operates normally when two ports are connected. When functioning properly, the connection remains stable even if one port gets disconnected. Is there a reason why both por...

hello. First of all, thanks a lot for your help. model : OS6360-PH24 OS version : 8.8.56.R02 GA, 8.9.73.R01 GA "aaa switch-access mode enhanced" After entering this command, an equipment reload error occurred. forced reboot, it kept rebooting again and again. "aaa switch-access mode d...

Currently, the service is operating normally.
VRRP status is also normal.

I want to know why there is no log in active and the service is disconnected within 1 minute.
Can you figure out the probable cause?

Solved.
By mistake, the u-boot version was 8.1.1.70.R01.

hello. First of all, thanks a lot for your help. We are using two 9700 backbones. No log occurred in the active backbone, but a vrrp toggled log occurred in the standby backbone, and a service failure occurred momentarily. Please tell me what is causing the vrrp toggled log and what I need to check....

thank you.
We are still watching as the disorder has not recurred.
If the disorder recurs, I will check the information you mentioned.

When upgrading the alcatel firmware, is there a version that must be installed as a minimum? If you are using a version lower than the version guided in the Minimum U-Boot section in the release note, please let us know if you need to upgrade sequentially equipment version OS6860-P24 : 8.1.1.689.R01...

Hello. A log related to "duplicate IP address" has occurred. log --- TUE FEB 15 00:07:25 2022 IP info 6/0 duplicate IP address 10.3.1.1 from port 6/1 eth addr e8e732:0e7320 TUE FEB 15 01:00:00 2022 IP info 6/0 duplicate IP address 10.3.1.1 from port 6/1 eth addr e8e732:0e7320 TUE FEB 15 02...

Thank you silvio.
Rebooted and it was resolved.