Alcatel Unleashed

Hi again, found it in the documentation ! On the Com Server, enter an IP Quality of Service COS number in the Ethernet parameters of the board, and configure the desired VLAN number and priority level for this COS (see: Configuring 802.1p/Q Parameters in IP QoS COS on page 815). Chapter 20 802.1p/Q ...

Hi there,
is it possible to configure a VLAN tag on a GA board ?
Thanks in advance.
Regards,
M.B.

Hi there,
I'd like to know if it is possible to permanently close the telnet port of a GD ?
So that it is not detected during security scan.
I know that a post already exists on this topic but long time ago and without answer
Thanks in advance.
Regards,
Maxime

Hi,
it works per user by creating a prefix and associate it to a programmed key. Doesn't work if you dial directly the prefix.
Regards,
M.B.

Hi all,
I've a configuration with many entities in my OXE with the centrex feature.
I would like to activate secret identity for some users only.
I know that I can do that for all a entity but is that possible to do it per user instead ?
Thanks in advance for you answer.
Regards,
M.b.

Hi vad,
thanks for you answer.
In the short delay I had, I finally recreated my config.
I'll try later your solution if needed.
Regards.
M.B.

Hi, in the mao I prepared, when I restore it in the prod OXE, the call restriction value set to 1000 (in the value in license of my lab OXE). But in the license of my prod OXE, the call restriction value is set to 0. So when I restore the mao in the prod OXE ant the I restore the OPS, I've got the p...

Hi all, I've a problem. I've prepare a PABX configuration on a lab OXE (R11.1) in order to restore it on a prod OXE. On this lab OXE, I had a license for call restriction service. In my prepared configuration, I do not use this functionnality. When I restore the mao on my prod OXE and I install the ...

Hi,
For redundancy purpose, is that possible to install 2 INT-IP3 board in the same crystal shelf ?
Regards,
M.B.

Hi,
I can call from my central area to a remote area using an ARS prefix.
But I cannot call from my remote area to the central area using the ASR prefix...
Any idea ?
Regards,
M.B.