Link between two 6850 witch copper 1G

[ArmALC]

I have two omniswitch 6850, I want to link both through a patch cord using the 1/24 combo port at both ends.

The link only works at fastethernet (disabling autonegotiation or placing it in half duplex some of the two omniswitch),

OSW1 1/24 Enable 100 Half C Auto Half PF -
OSW2 1/24 Enable 100 Half C Auto Auto PF -

but when setting the values speed, duplex and autoneg in auto mode on the two omniswitch ports turn on but no have traffic (not uncharable),


I would like to configure this link in gigaethernet mode so that it works as an uplink port (not fastethernet) only use this patch cord, is this possible? ?

[ArmALC]

Hello, changing the patch cords and isolating the network cabling from the middle, the link works fine at 1000mb.

So wiring limited the link to only 100mb.





1/24 Enable 1000 Full C 1000 Full PF -
1/24 Enable 1000 Full C Auto Auto PF -


greetings!!!