GD ip address

alex.marete · Post by **alex.marete** » 02 Apr 2010 05:53

Dear all,
I have an OXE R9.0. once i progran a static IP address in the GD, it doesnt connect to the CS. If i choose dynamic mode, its allocatd an address and system works correctly. Any idea why i cant use static ip.

Regards,
AM

komar_666 · Post by **komar_666** » 06 Apr 2010 10:28

Check your configuration, Ip, netmask, and Mac adress in oxe

sera544 · Post by **sera544** » 07 Apr 2010 01:30

Hi alex,

Check IP parameters>INTIP>Ethernet address checked by TFTP make it false, make sure u declare the GD mac address in the system, Now u can configure the static IP,

cheers

Post by **vad** » 07 Apr 2010 01:56

sera544 wrote:Hi alex,

Check IP parameters>INTIP>Ethernet address checked by TFTP make it false

cheers

For security reason IP parameters>INTIP>Ethernet address checked by TFTP = true
Just declare GD MAC address in Shelf/ Board/ Ethernet parameters

swinstation · Post by **swinstation** » 07 Apr 2010 12:53

IT happened to me today in r9.some of the others I turn the switch off and after turning on it worked but now it doesn't work.any idea?

alex.marete · Post by **alex.marete** » 08 Apr 2010 04:49

Further checks show that once i enter the IP addresses of both CPU in GD mgconfig, the GD never comes on. If i enter only the CPU address of the master CPU then the static address is recognized.
The system is duplicated.
Regards,

Post by **tot3nkopf** » 04 May 2010 05:24

lanpbxbuild configured ok?

Post by **vad** » 04 May 2010 05:42

If you have two CS in one LAN - manage CS role address in GD parameters.
If you have two CS in different LAN - for both CS you need to manage role addressing. And in mgconfig declare ROLE address for CS1 and CS2.