In an attempt to update the 6450 switch I mistakenly copied the 6350 image files to the certified folder of the 6450 switch.
The boot was through the miniboot, after many attempts to recover the switch via USB (which I did not recognize), ZMODEM and XMODEM without success, I did the procedure (attached) that I found here on the forum for 6350, some commands did not work others yes .
But after doing some commands and restarting the switch I can't see the boot anymore through the teraterm or putty through the console ...
do the disaster recovery for with the OS6450-image files KF*.img.
USB stick with folder 6450 - within 6450 the directory certified - and within certified the image files.
Than power on the switch with this stick.
Do not use a big stick - better is to use an older with max. 4GB (and FAT or FAT32).
regards
Silvio
What happend? Did you find a solution.
I would love to hear a followup on this one because I am in the same position that the switch is completely out of reach through console port.
silvio wrote: ↑10 Oct 2020 14:44
do the disaster recovery for with the OS6450-image files KF*.img.
USB stick with folder 6450 - within 6450 the directory certified - and within certified the image files.
Than power on the switch with this stick.
Do not use a big stick - better is to use an older with max. 4GB (and FAT or FAT32).
regards
Silvio
Hi,
I need to reinstall OS on Switch OS6450-P48.
I cannot access via Putty and the equipment does not generate any IP
could you show me how the file tree inside the flashdrive would look please?
Please test the stick at an other (working) 6450. Insert the stick, usb enable, show usb statistic, ls /uflash etc.
If this isn't working you need to use another stick (or format this one again with FAT).