I seem to fail in terms of getting a connection from something outside the the local subnet of the EMP interface.
So my question is can you use the EMP port for out of band managment ? You should be able to do that imho since there is a command to see what emp-routes you have in the machine.
However there is no way to configure emp-routes as I see it.
I'm a bit of a alcatel lucent noob so please bare with me =)
Below is my current config.
Code: Select all
mac-retention admin-state enable
mac-retention dup-mac-trap admin-state enable
mac-retention timer 30
! Configuration:
! Capability Manager:
! Multi-Chassis:
! Virtual Chassis Manager:
! Virtual Flow Control:
! Interface:
! Link Aggregate:
! VLAN:
vlan 1 admin-state enable
! Spanning Tree:
spantree vlan 1 admin-state enable
! Bridging:
! Port Mirroring:
! Port Mapping:
! IP:
ip service port 21 admin-state enable
ip service port 22 admin-state enable
ip service port 23 admin-state enable
ip service port 80 admin-state enable
ip service port 123 admin-state disable
ip service port 443 admin-state enable
ip interface emp address X.X.X.X mask 255.255.255.0
! IPv6:
! IPSec:
! IPMS:
! AAA:
aaa authentication console "local"
aaa authentication telnet "local"
! NTP:
! QOS:
! Policy Manager:
! VLAN Stacking:
! ERP:
! MVRP:
! LLDP:
! UDLD:
! Server Load Balance:
! High Availability Vlan:
! Session Manager:
! Web:
! Trap Manager:
! Health Monitor:
! System Service:
! SNMP:
! BFD:
! IP Route Manager:
ip static-route 10.10.48.0/22 gateway X.X.X.X metric 1
ip static-route 172.0.0.0/12 gateway X.X.X.X metric 1
! VRRP:
! UDP Relay:
! RIP:
! OSPF:
! ISIS:
! IP Multicast:
! DVMRP:
! IPMR:
! RIPng:
! OSPF3:
! BGP:
! Netsec:
! Module:
! RDP:
! DA-UNP:
! DHL:
! Ethernet-OAM:
! SAA:
! SPB-ISIS:
! SVCMGR:
! LDP: