Hi all,
We are facing a critical issue at one of our customers using R 7.0 on CPU7 with patch 24g.....there are numerous incidents shown after some interval atleast three times in a minute related to INTOF boards, the incidents are :
0000001M|00/27/-/---|=0:3660=status of 8KFS (0 is ok,1 is KO): 0, value:4 4
0000001M|00/27/-/---|=0:3660=status of 8KFS (0 is ok,1 is KO): 1, value:4 3
this incident is from one board and i am getting the incidents from all intofA boards connected in the system..I have tried resetting the board and also done bascul on both CPUs simultaneously but problem still persists, I have also replaced one of the CPUs with a new CPU and put the backup on it but still i am facing the same problem....One of my INTOFA is resetted automatically after numerous incidents which resulted in the shelf out of service. Do help me if any one can..
INTOF issue
Re: INTOF issue
It is a problem with ACT synchronization.
How is your main ACT is synchronized?
How is your main ACT is synchronized?
If it looks like a duck, swims like a duck, and quacks like a duck, then it probably is a duck.
Re: INTOF issue
Hi Xero
Please what was the solution for this problem,because I am facing same problem in one site?
Best Regards
Wadsultan
Please what was the solution for this problem,because I am facing same problem in one site?
Best Regards
Wadsultan
Re: INTOF issue
0000001M|00/27/-/---|=0:3660=status of 8KFS (0 is ok,1 is KO): 0, value:4 4
0000001M|00/27/-/---|=0:3660=status of 8KFS (0 is ok,1 is KO): 1, value:4 3
when connecting a link of intof2A &INTOF2B Iam getting this incedent and A was inservice & B out of service and showing only SYNC light.
Best Regards
Wadsultan
0000001M|00/27/-/---|=0:3660=status of 8KFS (0 is ok,1 is KO): 1, value:4 3
when connecting a link of intof2A &INTOF2B Iam getting this incedent and A was inservice & B out of service and showing only SYNC light.
Best Regards
Wadsultan
Re: INTOF issue
Dear all
I solved the problem by checking the fiber coupler (replaced) and complete system reboot( not bascul) and works fine.
Thanks
wadsultan
I solved the problem by checking the fiber coupler (replaced) and complete system reboot( not bascul) and works fine.
Thanks
wadsultan