Alcatel Unleashed

The #1 Worldwide board for technical support on Alcatel-Lucent Voice & Data gear.

Skip to content


Check out the AlcatelUnleashed mailing lists
Use TapaTalk from your iPad/iPhone/Android/Blackberry to browse AlcatelUnleashed with a great experience! 		AlcatelUnleashed recommends GIXEN for eBay Sniping!eBay Sniper

configuring 8118 sets

Post a reply

configuring 8118 sets

Postby beirut » Mon May 14, 2012 5:00 am

Need some help on how to config OmniTouch 8118Wlan Handset.
I found TC1435, but it s not describing the type of set that should be created on the OXE. And how to set up the set.

As for WinPDM from Ascom/Alcatel software, do I need it to configure 1 handset?
when I installed the WINPdm, could not see it in the programs. Is it a USB driver?

Thanks
beirut
Member
 
Posts: 50
Joined: Tue Feb 02, 2010 11:49 am
Top

Re: configuring 8118 sets

Postby manoj » Thu May 17, 2012 6:44 am

Hi,
In OXE create one user as mobile ip Touch..then the ip parameters option give the MAC address also. After in 8118 handset dial 40022 for admin menu and create one network..like IPaddress, tftp address,subnet,SSID,security....thats it
manoj
Member
 
Posts: 36
Joined: Tue May 17, 2011 7:32 am
Top

Re: configuring 8118 sets

Postby beirut » Thu May 17, 2012 6:54 am

thanks a lot.
And if I am using the USB cradle, where to find the template for the WinPDM? I did lot of search but could not find the .def for it.

Thanks again.
beirut
Member
 
Posts: 50
Joined: Tue Feb 02, 2010 11:49 am
Top
Post a reply

Return to Mobile IPTouch Phones (MIPT)

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB® Forum Software © phpBB Group
Creative Commons License
AlcatelUnleashed by AlcatelUnleashed is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License.
Based on a work at www.AlcatelUnleashed.com.
AlcatelUnleashed is NOT affiliated with or endorsed by Alcatel-Lucent.
Access our mailing lists here.